Hunter Douglas Nantucket PowerView, Установка Эксплуатация Уход

Страница: 6 / 32

INSTALLATION
4
Mount the Installation Brackets — Inside Mount
Prepare the Installation Brackets
The purpose of the back cover bracket is to
provide an attachment for the optional back cover.
The top tab ensures that there is clearance for the
battery wand.
■
If using the optional back cover:
➤
If you have a battery wand, do not remove
the top tab on the back cover bracket.
➤
If you have a satellite battery pack or an
18V DC power supply, remove the top tab
on the back cover bracket.
➤
Snap the back cover bracket into the metal
installation bracket.
➤
Place the back cover into the slots on the
top and bottom of the bracket.
■
If not using the optional back cover:
➤
If you have a battery wand, remove the
bottom tab from the back cover bracket.
➤
Snap the back cover bracket into the metal
installation bracket. This ensures adequate
space for the battery wand.
➤
If you have a satellite battery pack or an
18V DC power supply, it is not necessary
to use the back cover bracket.
Mount the Installation Brackets
■
Measure and mark end bracket locations 2" in from each jamb.
➤
If more than two installation brackets are required (see table on page 3), mark the
location of additional bracket(s) spaced evenly between the two end bracket locations.
Mount into wood whenever possible.
Allow a minimum of 18" from the motor side
for the battery wand.
2"
Motor
Side
2" Space Evenly
Jamb Jamb
Space Evenly
18" Minimum for Battery Wand
Remove top tab if using a satellite
battery pack or an 18V DC power supply.
Back Cover Bracket
Remove bottom tab if using a
battery wand and no back cover.
Top Tab
Bottom Tab
Back Cover
Slots