Hunter Douglas Nantucket PowerView, Установка Эксплуатация Уход

Страница: 21 / 32

OPERATION
19
Further Operation and Programming Information
PowerView
®
Pebble
®
Remote and/or PowerView Surface Remote Operation
For information regarding operation and programming of the PowerView remote, refer to your
PowerView Motorization
®
Remote Control Guide or to the online PowerView Step-by-Step Guide
at hunterdouglas.com/operating-systems/motorized/powerview-motorization/manuals .
PowerView
®
Scene Controller
For information regarding operation and programming of the PowerView Scene Controller, refer
to your
PowerView Motorization Scene Controller Guide or to the online PowerView Step-by-Step
Guide at
hunterdouglas.com/operating-systems/motorized/powerview-motorization/
manuals
.
PowerView
®
App Operation
The PowerView Hub
®
is required for PowerView App operation. For information regarding setup
and operation using the PowerView App, refer to the online PowerView Step-by-Step Guide at
hunterdouglas.com/operating-systems/motorized/powerview-motorization/manuals
.
Resetting the Shading (If Necessary)
Calibration Reset
The calibration reset is used to recalibrate the shading’s travel limits.
1. Press and hold the programming button for approximately 6 seconds. The shading will move
slightly. Release the programming button (the light flashes red).
2. The shading will raise to its fully open position to reestablish the upper travel limit, then lower
to the fully closed position with vanes open to reestablish the lower travel limit. The shading
will move slightly twice (up, then down) to indicate that the travel limits were recalibrated.
Resetting Shading Programming
The programming reset erases shading programming from memory, including group
assignments, preventing input devices from operating the shading. The primary use is to correct
group and network assignments during installation. The reset does not affect travel limits or the
favorite position.
1. Press and hold the programming button for approximately 12 seconds. The shading will move
slightly after 6 seconds, then again after 12 seconds. Release the programming button (the
light flashes red). The light then flashes a series of green and red to indicate that shading
programming is erased from memory.
2. Refer to “Joining a Shading to a Group” on page 17 to program the shading to a group.