Hunter Douglas Nantucket PowerView, Установка Эксплуатация Уход

Страница: 23 / 32

OPERATION
21
Problem The shading is not responding to the PowerView
®
remote.
Solution IMPORTANT:
A shading will not operate using the remote until it has been joined
to a group.
Check that the correct group number is selected.
Check that the batteries in the remote are correctly inserted and are fresh. The LEDs
that backlight the remote should come on full bright when
■
STOP is pressed.
Problem The vanes do not open when the shading is first operated.
Solution
Make sure the shading is completely lowered.
Open and close the shading several times to help open the vanes. If necessary,
gently pull down on the bottom rail.
Problem The shading is hard to raise or lower, or the bottom rail does not stop at the
top limit.
Solution Check the adjustment position of both
limit stops. The top illustration shows the
correct adjustment. The limit stop catches
the bottom rail, and the bottom of the limit
stop is slightly above or barely touching
the fabric roll.
In the second illustration, the limit stop
adjustment is too tight. The fabric may not
drop freely and could even be damaged
when the shading is raised. To correct
this, the limit stop should be adjusted one
step up. Simply pull back on the rear of
the limit stop to adjust its position.
In the bottom illustration, the adjustment
is too loose. The bottom rail can slip under
the limit stop. If the bottom rail rotates
through the headrail, it must be backed
out before adjusting the limit stop.
IMPORTANT:
Both limit stops must
be adjusted to the same position or else
skewing may occur.
Pull Back
to Adjust
Fabric Roll
Bottom
Rail
Limit Stop Headrail
Pull Back
to Adjust
Too Tight —
Adjust One Step Up
Too Loose —
Adjust One Step Down