Hunter Douglas ALPHA Series, Инструкция по установке и измерениям

Страница: 27 / 52

Page 25
STEP 3 - REMOVAL OF FLOATING GUIDE
a) Lift black floating guide towards
top of channel about 2mm and
tilt bottom guide towards middle
of awning.
b) Pull floating guide towards user and lower guide so bottom end comes
out first.
Note: If this cannot be removed loosen bolt on top end cap.
STEP 4 - POSITION THE SIDE CHANNEL
A. Install the headbox back plate,
level the headbox before fixing
with the specified screws
through the Universal Mounting
Brackets.
B. Install the DC ZC CHANNEL
V2, for on face install use a
spirit level to ensure the side
channel is vertical and squared
on the head box, for reveal
mount directly to the substrate
(for reveals up to 20mm out of
square).
C. Install the fabric roll onto the
head box and secure with the
supplied safety pin.
D. Lower the bottom rail at least
100mm or 1/2 of the drop
(power up the motors and use
the remote if motorised)
** The factory will cut the zip with a 30mm to 40mm tail, which should not be cut off on install. This will ensure an easier feed on of the
guide and ensure the zip will not exit the top of the ZS guide if the awning is “over-raised”. The tail will collapse into to bottom of the
side channel when the awning is down.
1
2
B
A
C
D
ALPHA AWNING SERIES INSTALLATION MANUAL