www.humancaregroup.com
11
Changing the hand control - Altair
ENG
1. Follow the steps 1-6 in the “opening the lift
chapter”.
2. Remove the connector on the hand control
cable from the circuit board (PCB) by
pressing on the small plastic lock on the left
side.
3. Remove the two screws from the cable
holder with a torx screwdriver 10 mm (T10).
4. Remove the rubber seal from the cover.
5. Pull the cable and the connector out through
the hole.
6. Repeat the steps in reverse in order to
connect the new hand control.
If the hand control is damaged/broken,
the cable can be cut to make it easier to
remove the cable.
