S1700 Managed Series Ethernet Switches
Web User Manual
4 Interface Management
Issue 05 (2012-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
32
Item
Description
Load Balancing Mode Select the standard of flow distribution among member interfaces
on Trunk group. The options are:
Source MAC
Destination MAC
Source and Destination MAC
Source IP
Destination IP
Source and Destination IP
4.2.2 Trunk Configuration
Click Interface Management > Eth-Trunk to enter configuration page where Trunk can be set
up, to configure member interface number and configure connection parameters
Figure 4-6
Trunk List
Table 4-5
Parameters of Trunk List
Item
Description
Trunk ID
Configured trunk number (Range: 1-12)
Types
Manual Trunk or Static LACP mode supports 12 Trunks
(up to eight member interfaces in each group).
Min Active Links
The minimum active interfaces in the group.
Max Active Links
The maximum active interfaces in the group.
Preempt Delay State
The active port with lower priority in LACP aggregation
group can be replaced by the backup port with higher
priority when LACP Preempt is enabled, at this time the
port with higher priority will become active port, and the
port with lower priority become the secondary port. If
LACP Preempt is disabled, the replacement will not
happen.
Preempt Delay Time(s)
The backup port with higher priority replaces the active
port with lower priority after a designated time. It will only
relevant when LACP Preempt is enabled.
Select interface
The interface number set as Trunk member.
