EDGE U0-6 Simplified Maintenance Manual
8 Assembly Procedure
Issue 1.0 (2013-01-12)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
44
31. Take a GPS antenna support, attach a piece of
the camera hole protective film to the support, and
install the support to the front cover.
32.After you install the GPS antenna support, place the
phone to the antenna screw tightening jig. Close the jig
cover and tighten the screws in sequence.
Criteria: no screws or threads are stripped ou
The fourth screw change to a white screw, which item
code is
51623418
33. Attach a tamper-resistant label and to the screw
in the upper left corner of the battery and a
waterproof label next to the camera. then press the
label using a cotton swab.
34. Check that the LCD FPC's ground pad is properly
attached, remove the release paper from the battery
compartment, and attach the battery by aligning it with
the side of the compartment next to the PCBA. Check
that the coaxial cable is above the battery FPC. If not,
adjust the cable's position.
35. After the battery is properly attached, hold the
phone between your palms and press it for 5–6
seconds with a force of 160–240 N.
36. Attach the IMEI label to the position shown in the
above figure.
A. Fasten
the main
antenna
buckle.
B. Fasten the two
buckles.
C. Fasten the three
buckles from left to right.
D. Fasten this
buckle at last.
Tamper-resistant label
Waterproof label
