EDGE U0-6 Simplified Maintenance Manual
8 Assembly Procedure
Issue 1.0 (2013-01-12)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
45
37. Attach a tamper-resistant label and waterproof
label to the screw shown in the above figure.
Criteria: The label is securely attached without
defects.
38.Use the tweezers to get a Electric Foam, the item
code is 51634743 . then attach the electric form between
the A cover and the shielding Frame by aligning it with
the line in the picture.
Criteria: The Electric Foam can’t be higher than the step
of the A cover next to the electric form.
39. Remove the board SN label, camera hole
protective film, and release paper on the rear
camera lens.
40.get 1pcs Conductive Foil which item code is
51634744. then attach the conductive foil to the GPS
antenna support by aligning it with the upper-left corner
of the front camera.
Criteria: The conductive foil can’t cover on the frame of
A cover.
41. Take a battery cover and remove the release
paper from the lower part of the cover. Check that
the IMEI label and tamper-resistant label are
properly attached and install the battery cover to the
phone. Ensure that the battery cover is smoothly
installed, with all buckles fastened.
42. Place the phone into the battery installing jig. Close
the jig cover and push the handle of the jig.
Waterproof label
Tamper-resistant label
red line and the electric form
