HTP EL-110, Руководство по установке

Страница: 13 / 97

13
4. Gas control system components must be protected from dripping water during operation and service.
5. If the boiler is to replace an existing boiler, check for and correct any existing system problems, such as:

System leaks

Location that could cause the system and boiler to freeze and leak.

Incorrectly-sized expansion tank
6. Clean and flush system when reinstalling a boiler.
NOTE: When installing in a zero clearance location, it may not be possible to read or view some product labeling.
It is recommended to make note of the boiler model and serial number.
Do not mount the boiler to a hollow wall. Mount to the studs only. Failure to do so will result in substantial property
damage, and could result in severe personal injury or death.
Use extreme care not to drop the boiler or cause bodily injury while lifting or mounting the boiler onto the optional
wall mount bracket. Failure to do so will result in property damage, and could result in severe personal injury or
death.
Gas conversion should be performed BEFORE the boiler is installed. Carefully follow the gas conversion
instructions when performing the conversion. Failure to do so could result in property damage, severe personal
injury, or death.
B. LEVELING AND DIMENSIONS
In order for the condensate to properly flow out of the
collection system, the area where you locate the boiler
must be level. The boiler comes equipped with
leveling feet. Should you find the floor beneath the
boiler is uneven, adjust the leveling feet with a wrench.
Figure 1
– Leveling