HT PVCHECK, Руководство пользователя

Страница: 45 / 56

PVCHECK 43
MESSAGE DESCRIPTION
Negative voltage
Check the polarity of the instrument’s input terminals
Low voltage Check the voltage between input terminals P and N
Vin > 1000 Voltage between input terminals > 1000V
Wrong no. of modules.
Continue?
Set no. of modules inconsistent with measured Voc
Ref. cell temp. exceeding limits Temperature measured by reference cell too high
Cell temp. undetected
(ENTER/ESC)
Measurement not carried out on module cell
Low battery Low battery charge. Insert new batteries.
Please wait for cooling…
Instrument overheated. Wait before resuming the test.
Irradiance too low Irradiance value lower than the minimum threshold set
NTC Error Internal NTC efficiency jeopardized. Contact service department
Isc current too high Measured Isc current > 10A
Current < Lim Current between P and N lower than the minimum detectable value
EEPROM error: contact service Internal instrument error
FRAM error: contact service Internal instrument error
RTC Error: contact service Internal instrument error
RADIO error: contact service Internal instrument error
FLASH error: contact service Internal instrument error
IO EXP error: contact service Internal instrument error
Voltage > limit Voltage between terminals E and C > 10V
Label already assigned
Change the numeric reference of the marker associated with the
measure
Isc current < Lim
Isc current lower than the minimum detectable value. Contact service
department
CAUTION: internal short-circuit Contact service department
CAUTION: blown fuse Contact service department
Reset calibration. Press
ENTER.
Resistance value of input cables > 2
Ω
Calibration not OK Calibrated resistance value > measured resistance
Error: Isc offset measurement Internal instrument error
Rcal > measured R Calibrated resistance value > measured resistance
CAUTION: AC voltage at P-N
terminals
Presence of AC input voltage
Wait for condenser discharge Wait for discharge of tested object after insulation