HRS CL901-0001-0, Инструкция по эксплуатации

Страница: 4 / 28

ii
1. To protect against shock hazards when opening the cover, first turn the power off. Then, wait
for a minimum of five minutes before opening the cover.
SAFETY INSTRUCTIONS
DANGER
Basic safety instructions
1. Be sure to read this Instruction Manual and any other instructions or materials supplied with
the unit as accessories. Keep this Instruction Manual and make it available for reference.
Safety device and warning labels
1. To avoid possible accidents due to lack of the safety device, be sure to operate the machine
after ascertaining that the safety devices are properly installed at the predetermined position.
Refer to page iv for description of the safety devices.
2. If the safety device is detached from the machine for any reason, replace it to its original posi-
tion and check to be sure that it normally functions.
3. Be sure to maintain the warning labels on the machine. They should be clear and visible at all
times. If any of the warning labels should come off or become soiled/damaged, replace it with a
new one.
Application
1. This machine shall only be used as specified in this Instruction Manual.
2. Modifications to this machine is prohibited. We assume no responsibility for accidents resulting
from modifications.
Operating environment
1. To avoid accidents caused by malfunction, the machine shall be operated under an environment
that is not affected by high noise sources (electromagnetic waves) such as high-frequency
welders.
2. To avoid accidents caused by malfunction, the machine shall not be used in such an environ-
ment that would subject it to any voltage rating outside of "rated voltage ±10%".
3. The machine shall be used under the following environment for safety.
Atmospheric temperature under operating conditions : 5°C to 35°C
Relative humidity under operating conditions : 35% to 85 %
4. Condensation can be observed when the environment of the machine is changed abruptly from
cold to warm. To avoid accidents or damage, do not operate this machine in condition where
the humidity is greater than the upper limit of the relative humidity specified above.
5. To avoid accidents caused by a damaged electrical part function, in the event of thunder and
lightning, stop your work and pull out the power plug.
Training
1. To prevent possible accidents caused by unfamiliarity with the operation of the machine, the
machine should only be operated by fully trained personnel.
It is recommended that a training procedure be established by the employer and that the opera-
tor be provided with this Instruction Manual for reference.
Working wear
1. To protect against possible accidents resulting in personal injury or damage to personal prop-
erty (i.e., clothing), be sure wear a work uniform or fit clothing with sleeve cuffs fastened.
2. The operator should secure their hair with a hat or ponytail to protect his/her hair from being
caught in the machine.
3. The operator should wear safe, rubber bottom, close toe shoes or work boots.
Event that requires turn-off of the power
1. In the event of abnormal conditions, machine failure or power failure, the power should be
turned off immediately.
2. To protect against possible accidents caused by abrupt start of the machine, the power must be
turned off before conducting inspection, repair, or cleaning. Be sure to turn the power off when
the operator leaves the machine.
3. To pull out the power plug, hold the plug rather than the cord.
* In all this document,"Turn-off the power" means turning off the power switch and pulling the
power plug out of the receptacle.
CAUTION
* For the purpose of this manual, an accident is an event that causes personal injury or damage to
property.