IMPORTANT:
Replacing the system board battery resets the system ROM to its default
configuration. After replacing the battery, reconfigure the system through UEFI System Utilities.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Removing and replacing the system board
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
on page 28).
2.
on page 28).
3.
Place the server on a flat, level work surface.
4.
on page 29).
5.
Open the front bracket (
on page 29).
6.
Remove the air baffle (
on page 30).
7.
Remove the rear support bracket (
Removing the rear support bracket
on page 31).
8.
9.
Remove the M.2 enablement backplane (
Removing and replacing the M.2 enablement backplane
page 34).
10.
Remove the mezzanine card (
Removing and replacing the mezzanine card
on page 36).
11.
Remove the processor-heatsink module (
Removing and replacing the processor
on page 40).
12.
Disconnect all cables from the system board.
Removal and replacement procedures
45
Содержание ProLiant XL230k Gen10
