Procedure
1.
Power down the server (
on page 28).
2.
Remove the server (
on page 28).
3.
Place the server on a flat, level work surface.
4.
Remove the access panel (
on page 29).
5.
Open the front bracket.
NOTE:
Depending on the server configuration, the HPE Smart Storage Battery or the M.2 enablement
backplane might be installed on the front bracket.
Removing the air baffle
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
Power down the server (
on page 28).
2.
Remove the server (
on page 28).
3.
Place the server on a flat, level work surface.
4.
Remove the access panel (
on page 29).
5.
on page 29).
6.
Remove the air baffle.
30
Removal and replacement procedures
Содержание ProLiant XL230k Gen10
