The following alert appears:
Product ID is modified only by qualified personnel. This value must match the
product ID located on the chassis.
7.
Type the product ID and press
Enter
.
8.
Press
F10
to save the configuration.
The procedure is complete.
Removing and replacing the I/O riser module
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
Power down the server that contains the I/O module riser you are replacing (
on
page 28).
2.
Remove the riser from the I/O module.
3.
Remove the riser cover.
Removal and replacement procedures
47
Содержание ProLiant XL230k Gen10
