HPE ProLiant DX190r Gen10, Руководство по техническому обслуживанию и ремонту

Страница: 58 / 130

To replace the component, reverse the removal procedure.
For DIMM configuration information, see the Hewlett Packard Enterprise website ( http://www.hpe.com/
docs/arm-population-rules ).
Removing and replacing the system board
Removing the system board
Prerequisites
• Take note of the following:
◦ The slot locations in which each memory module is installed. These components must be installed
in the same locations on the new system board.
◦ The port numbers and cable connections between the system board and the secondary riser
board.
• Before you perform this procedure, make sure that you have a T-15 and T-30 Torx screwdrivers
available.
Procedure
1. Power down the server on page 27.
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis on page 27.
4. Remove the bayonet board on page 28.
5. Remove the secondary riser cage on page 30.
6. Do one of the following:
• Remove the primary riser blank on page 33.
• Remove the primary riser cage on page 32.
7. If installed, remove the Media Module adapter .
58 Removal and replacement procedures