4.
Connect all peripheral cables to the server.
on page 41.
Power up the server
The DX chassis firmware initiates an automatic power-up sequence when the servers are installed. If the
default setting is changed, use one of the following methods to power up each server:
• Use a virtual power button selection through iLO 5.
• Press and release the Power On/Standby button.
When the server goes from standby mode to full power mode, the server power LED changes from amber
to green.
Disconnecting and replacing the SUV cable
Procedure
1.
Disconnect the peripheral devices connected to the SUV cable.
2.
Disconnect the SUV cable:
a.
Press and hold both sides of the SUV connector.
b.
Disconnect the cable from the SUV port.
Removal and replacement procedures
41
Содержание ProLiant DX190r Gen10
Страница 21: ...Customer self repair 21...
Страница 22: ...22 Customer self repair...
Страница 23: ...Customer self repair 23...
