5. Remove the secondary riser cage
on page 30.
6.
If an expansion board with internal cabling is installed on the riser cage, disconnect these internal
cables from the expansion board.
7.
Remove the primary riser cage.
Remove the primary riser blank
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
either riser blank or the riser cage is installed.
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
on page 27.
2.
Disconnect all peripheral cables from the server.
3. Remove the server from the chassis
on page 27.
5. Remove the secondary riser cage
on page 30.
6.
Remove the primary riser blank.
Removal and replacement procedures
33
Содержание ProLiant DX190r Gen10
Страница 21: ...Customer self repair 21...
Страница 22: ...22 Customer self repair...
Страница 23: ...Customer self repair 23...
