HPE ProLiant DX190r Gen10, Руководство по техническому обслуживанию и ремонту

Страница: 28 / 130

CAUTION: To avoid damage to the server or server blank:
• Always support the bottom of the server or server blank when removing it from the chassis.
• Do not use the release lever to carry the server or server blank.
Procedure
1. Power down the server on page 27.
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis:
a. Loosen the thumbscrew.
b. Open the release lever.
c. Use the release lever to pull the server out of the chassis.
Remove the bayonet board
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1. Power down the server on page 27.
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis on page 27.
4. Remove the bayonet board:
a. Remove the screws securing the cover to the bayonet board.
28 Removal and replacement procedures