HP NetServer e 800, Руководство по обслуживанию

Страница: 69 / 103

63
6 Replacing Parts
Safety Information
Follow the procedures listed below to ensure safe handling of components and to prevent harm to both you
and the server:
• Use an anti-static wrist strap and a grounding mat, such as those included in the Electrically
Conductive Field Service Grounding Kit (HP 9300-1155).
•
Handle accessory boards and components by the edges only. Do not touch any metal-edge
connectors or any electrical components on accessory boards.
•
Do not wear clothing subject to static charge build-up, such as wool or synthetic materials.
WARNING Hazardous voltages are present inside the server. Always remove AC power from
the CPU and other associated assemblies while working inside the unit. Serious
injury may result if this warning is not observed.
Service Tools Required
Service of this product may require one or more of the following tools:
•
Electrically Conductive Field Service Kit (P/N 9300-1155)
• CE Peripheral Exerciser Disk Kit (45935-63210)
• Datacomm Test Hood, 9-pin (24540-60010)
•
Datacomm Test Hood, 25-pin parallel (24540-60011)
•
1/4 inch Flat Blade Screwdriver
•
T-15 Torx
®
Screwdriver
Front Panel Bezel
Removing the Bezel
1. If the NetServer is operating, power down the NetServer.
2. Disconnect the power cord and any external cables connected to the NetServer. If necessary,
label each one to expedite re-assembly.
3. Undo the six thumbscrews securing the cover to the chassis.
4. Remove the cover.
5. Where the six bezel tabs are connected to the six slots on the chassis, release the tabs by
applying outward pressure on the tabs, gently pull the bezel forward and away from the chassis.