HP NetServer e 800, Руководство по обслуживанию

Страница: 59 / 103

Chapter 5 Troubleshooting
53
c. If there is still a problem, remove the video adapter board, and enable the internal video
system. Verify the problem.
18. If a message appears such as "INVALID CONFIGURATION", run the Setup Utility and press
[F2] during the boot process or boot the HP Navigator CD-ROM) to confirm the NetServer video
configuration. Make sure other accessory boards do not use the same memory addresses as
the HP video system.
19. If the problem is isolated to the built-in video system, replace the system board.
20. Once a suspect part has been found, verify it is the problem by reinstalling the part and
duplicating the error.
Configuration Problems
Symptom:
•
An installed driver cannot find a PCI board
Installing a PCI board which bridges the two system PCI buses (certain adapter boards provide this feature)
can cause previously installed PCI drivers to not recognize their adapter board(s).
To resolve the configuration problem, move the PCI board that has bridging capability to a primary PCI slot.
Symptom:
•
The configuration cannot be saved and the battery loses power
Refer to this section if the NetServer frequently loses date and time that may be caused by the battery losing
power.
1. Review the Troubleshooting Checklist before you continue.
2. If the NetServer frequently loses the time and date, replace the battery. The battery is attached
to the system board.
3. Set the new date and time, and reset the configuration parameters using the Setup Utility, if
necessary.
4. Turn off AC power to the NetServer, then reboot to see if the date and time was saved.
5. If date and time are still requested, and the battery is good, perform the next procedure, below.
If your HP NetServer repeatedly loses its configuration or the clock stops, you should replace the battery or
install an external battery.
WARNING There is a danger of explosion if the battery is incorrectly installed. For your safety,
never attempt to recharge, disassemble, or burn the old battery. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
Symptom:
•
The configuration information is frequently lost and the battery is good
If the battery is good and you cannot save system configuration, do the following