HP NetServer e 800, Руководство по обслуживанию

Страница: 39 / 103

Chapter 4 Diagnostics
33
Code Description Problem/Solution
configure the PCI devices.
3. Check for any further PC resource, which can be
used. Use Setup Utility to disable any unused
function, such as I/O ports or IDE controllers.
4. Start the Operating System and let it update the PCI
configuration.
0022 Plug & Play ISA initialization
problem
(This does not apply to
E 800) The Plug & Plug ISA accessory board has reported an
initialization problem. The ROM on the accessory board is
bad or the Plug & Play BIOS cannot solve a conflict issue
with a system board reserved resource.
To correct this:
1. Clear the Plug & Play configuration with the CMOS
status switch. Refer to the User's guide for details.
2. Try to disable (free) resources used by system board
devices.
3. Run the Plug & Play utility supported by your
Operating System.
4. If the problem persists, the accessory board may be
defective. Contact the accessory board vendor.
0030 Processor Speed selection
problem
(This does not apply to
E 800) POST has detected the processor speed selected with
system board switches does not match the processor's
speed.
Refer to the User's guide for the correct switch setting.
0040 PC Serial Number
initialization problem POST has detected the PC Serial Number has been lost or
has not been initialized.
Pressing <F2> will automatically run the HP Serial (BIOS)
Utility and allow you to enter the Serial Number.
0050 Processor Cooling/Heating
problem POST has detected a cooling fan problem.
The processor cooling-fan needs to be connected.
0076 Integrated HP NetRAID
processor is not responding.
(This does not apply to
E 800) This problem will prevent the operation of the Integrated HP
NetRAID, if it is enabled. The problem may also prevent
operation of some PCI slots.
1. Flash the Integrated HP NetRAID firmware and
reboot the system.
2. If the error persists, your I/O board may need to be
replaced. Contact your service representative.