HP Kayak XU 03xx PC Workstation — Installing Accessories In Your HP PC Workstation
Installing Memory
8
English
Installing Memory
Main Memory Modules
If you need more main memory to run your application software, you
can install up to 1GB of memory in four DIMM slots.
Main memory upgrades are available in single 32 MB, 64 MB and
128 MB Unbuffered ECC SDRAM or 256 MB Registered ECC SDRAM
memory modules.
You should note that Registered ECC SDRAM
cannot be used with Unbuffered memory modules. Do not attempt to
combine these two types of memory.
CAUTION
Static electricity can damage electronic components. Turn off all
equipment. Do not let your clothes touch the accessory.
To equalize the static electricity, rest the accessory bag on top of the
power supply while you are removing the accessory from the bag.
Handle the accessory as little as possible and with care.
To install a main memory module:
1
Disconnect the computer’s power cord and any LAN or
telecommunications cable.
2
Remove the computer’s cover (refer to page 3).
3
Press the retaining buttons on each side of the HP UltraFlow airflow
guide and lift it partly out of the PC Workstation’s case.
4
Remove the fan connection to the system board and lift the airflow
guide completely out of PC Workstation’s case.
NOTE
Refer to the illustration on page 6 for steps 3 and 4.
5
Remove the Ultra wide 16-bit SCSI cable from the system board.
6
Remove the power supply and the transparent airflow guide
covering the processor sockets (if needed).
7
Remove the floppy disk drive data cable from the system board.
03xx-i~1.fm Page 8 Tuesday, February 16, 1999 10:15 AM
