HP Kayak XU 03xx PC Workstation — Installing Accessories In Your HP PC Workstation
Installing Mass Storage Devices
20
English
9
Locate the appropriate data cable for the disk drive.
10
Connect the data and power cables to the rear of the device. (
The
connectors are shaped to go in one way only
.)
11
Slide the power supply back into position, and tighten the four self-
retaining screws (refer to page 7).
12
Replace the HP UltraFlow airflow guide and reconnect the fan to the
system board (refer to the illustration on page 6).
13
Install any other accessories before replacing the cover and
completing the installation.
14
Follow the instructions below to complete the installation.
IDE drives should be connected to a
free IDE connector on the IDE cable
(you can add up to two IDE devices).
Wide SCSI devices should be
connected to a free SCSI connector
on the SCSI cable (you can add up
to five SCSI devices).
Narrow SCSI devices should be
connected to a free SCSI connector on
the SCSI cable (you can add up to two
SCSI devices).
Up to 13 external SCSI devices can be
connected via the external SCSI
connector.
Power Cable
Data Cable
03xx-i~1.fm Page 20 Tuesday, February 16, 1999 10:15 AM
