HP Kayak XU 03xx PC Workstation — Installing Accessories In Your HP PC Workstation
Installing Mass Storage Devices
18
English
9
Connect the power cable and the data cable to the rear of the drive.
(
The connectors are shaped to go in one way only
.)
10
Install any other accessories before completing the installation.
11
Turn to page 21 to complete the installation.
Installing a Hard Disk Drive in a Front-Access Shelf
NOTE
To ensure your hard disk drive is properly located and cooled, you
should only install drives that are up to one inch (1”) in height and of a
speed equal to or less than 7200 rpm in this shelf.
1
Disconnect the computer’s power cord and any telecommunications
cable.
2
Remove the computer’s cover (refer to page 3).
3
Remove the fan connection to the system board (refer to page 6).
4
Press the retaining buttons on each side of the HP UltraFlow airflow
guide and lift it out of the PC Workstation’s case.
5
Slide out the power supply to provide better access to the disk drive
cables (refer to page 6).
6
Unscrew and remove an unused drive tray.
Data Cable
Power Cable
Remove the
drive tray
03xx-i~1.fm Page 18 Tuesday, February 16, 1999 10:15 AM
