HP HPE 3PAR StoreServ 8000, Руководство по установке

Страница: 140 / 152

•
Remove all watches, rings, or loose jewelry when working in hot-plug areas of an energized
server and storage products
•
Do not attempt to defeat safety interlocks (where provided)
•
Some products have covers or doors to access hot-plug components and might allow access
to hazardous energy circuits or moving fans:
◦
The doors should remain locked during normal operation.
OR
◦
The product should be installed in a controlled access location where only qualified
personnel have access to the product
•
Power down the equipment and disconnect all AC OR DC power cords before removing any
access covers for non-hot-plug areas
•
Do not replace non-hot-plug components while power is applied to the product. First, shut
down the product and disconnect all AC OR DC power cords
•
Do not exceed the level of repair specified in the procedures in the product documentation.
All troubleshooting and repair procedures are detailed to allow only subassembly or
module-level repair. Because of the complexity of the individual boards and subassemblies,
do not attempt to make repairs at the component level or to make modifications to any printed
wiring board. Improper repairs can create a safety hazard
•
Verify that the AC OR DC power supply branch circuit that provides power to the rack is not
overloaded. This will reduce the risk of personal injury, fire, or damage to the equipment.
The total rack load should not exceed 80 percent of the branch circuit rating. Consult the
electrical authority having jurisdiction over your facility wiring and installation requirements
Power Cords
To reduce the risk of electric shock or damage to the equipment:
•
Use an approved AC OR DC or DC power cord, as appropriate. If you have questions about
the type of power cord to use, contact your Hewlett Packard Enterprise authorized service
provider
•
If you have not been provided with a power cord for your product or for any AC-powered
option intended for your product, purchase a power cord that is approved for use in your
country
•
You must use a power cord rated for your product and for the voltage and current marked
on the electrical ratings label of the product. The voltage and current rating of the cord must
be greater than the voltage and current rating marked on the product
•
Do not place objects on power cords or cables. Arrange them so that no one can accidentally
step on or trip over them
•
Do not pull on a cord or cable. When unplugging from the electrical outlet, grasp the cord
by the plug
•
Make sure that the total ampere rating of all products plugged into an extension cord or
power strip does not exceed 80 percent of the ampere ratings limit for the extension cord or
power strip
•
Do not disable the power cord grounding plug. The grounding plug is an important safety
feature
•
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at
all times, or connect to an approved DC source
140 Warranty and regulatory information