HP HPE 3PAR StoreServ 8000, Руководство по установке

Страница: 103 / 152

2. Verify that the following has been completed for the 3PAR StoreServ Storage:
•
Powered on
•
Connected to the same network subnet as the SP
•
Non-initialized to allow the SP to verify the 3PAR StoreServ Storage serial number
3. Click the Generate SP ID button.
4. After the SP ID is generated, click Next to proceed to the next wizard step.
SP Wizard step 3—Networking
The Configure Service Processor Networking page shows the information that is required to
configure the SP. To complete this section, use the completed installation checklist from
HPE 3PAR StoreServ 8000 Site Planning Manual as reference.
NOTE: For additional information and help, use the 3PAR SmartStart online help (accessible
by pressing F1 ).
1. Enter the SP information in the following fields:
•
SP hostname
•
IP Address (static)
CAUTION: Be sure to enter the permanent SP IP address. If you continue to use the
temporary SP IP address, you might prevent additional system setups from being
completed successfully.
•
Subnet Mask
•
Gateway
To adjust the network speed, expand the Advanced option to change the settings.
If you are setting up a VSP , enter the permanent IPv4 address that you want to assign to
it.
2. Do NOT check the Enable DNS Support box or enter values for Domain IP Addresses or
DNS Server(s) .
WARNING! Do NOT configure DNS settings using the SP setup wizard; instead, manually
configure DNS using the 3parcust account after successfully completing the installation.
To manually configure DNS settings after installation, in SPOCC, click the SPMAINT tab,
select option 2 —
Network Configuration , then select option 9 — DNS Configuration .
If you do configure DNS using the SP setup wizard, you must reinstall the Service
Processor software and begin the SP initialization using the SP setup wizard again .
3. Click Next to proceed to the next wizard step.
HPE 3PAR Service Processor Setup Wizard 103