HP Fabric OS 7.1.0, Руководство администратора

Страница: 295 / 666

Fabric OS Administrator’s Guide 295
53-1002745-02
Adding and moving ports on a logical switch
10
Example of deleting the logical switch with FID 7
switch_4:FID4:admin> lscfg --delete 7
All active login sessions for FID 7 have been terminated.
Switch successfully deleted.
Adding and moving ports on a logical switch
This procedure explains how to add and move ports on logical switches.
You add ports to a logical switch by moving the ports from one logical switch to another. See
“Supported platforms for Virtual Fabrics” on page 286 for port restrictions.
If you want to remove a port from a logical switch, you cannot remove it from the logical switch; you
must move the port to a different logical switch.
When you move a port from one logical switch to another, the port is automatically disabled. Any
performance monitors that were installed on the port are deleted. If monitors are required on the
port in its new location, you must manually reinstall them on the port after the move.
Notes
•
If the logical switch to which the port is moved has fabric mode Top Talkers enabled, then if the
port is an E_Port, fabric mode Top Talker monitors are automatically installed on that port.
•
If you are deploying ICLs in the base switch, all ports associated with those ICLs must be
assigned to the base switch. If you are deploying ICLs to connect to default switches (that is,
XISL use is not allowed), the ICL ports should be assigned (or left) in the default logical switch.
Use the following procedure to add or move ports on a logical switch:
1. Connect to the physical chassis and log in using an account with the chassis-role permission.
2. Enter the lsCfg command to move ports from one logical switch to another:
lscfg --config fabricID -slot slot -port port
The ports are assigned to the logical switch specified by fabricID and are removed from the
logical switch on which they are currently configured.
If the -port option is omitted, all ports on the specified slot are assigned to the logical switch.
NOTE
On the Brocade DCX and DCX 8510-8, the lscfg command does not allow you to add ports 48–
63 of the FC8-64 blade to the base switch. These ports are not supported on the base switch.
The Brocade DCX-4S and DCX 8510-4 do not have this limitation.
3. Enter y at the prompt.
The ports are automatically disabled, then removed from their current logical switch, and
assigned to the logical switch specified by
fabricID .
Example of assigning ports 18 through 20 to the logical switch with FID 5
sw0:FID128:admin> lscfg --config 5 -port 18-20
This operation requires that the affected ports be disabled.
Would you like to continue [y/n]?:
y
Making this configuration change. Please wait...
Configuration change successful.
Please enable your ports/switch when you are ready to continue.