HP EX485 - MediaSmart Server - 2 GB RAM, Руководство пользователя

Страница: 235 / 336

Troubleshooting & FAQs
•
On the back of the server, hold in the Power button for at least 4 seconds to force the
server to shutdown.
•
After the server is completely off, locate the recessed Status/Recovery button on the
front of the server and prepare to press this button with a paper clip.
•
On the back of the server, press the Power button to restart.
•
While the Health indicator is blinking aqua white and red , use a paper clip to
press the recessed Status/Recovery button until it clicks.
Recovery mode is initiated.
•
If recovery mode is successfully initiated, the Health indicator light blinks pink and red
repeating. After alternating a few times, the Health indicator light turns solid pink.
6. On the Rebooting your server into recovery mode dialog box, click Next , and then follow the
instructions on each dialog box.
During the recovery process, the following may happen:
•
If the recovery program cannot find the server, see No server found below.
•
If the Server Recovery cannot recover the partition data, the progress bar will go to 100%
and then back to zero and start over.
•
If the recovery fails, see Recovery fails .
7. After the Server Recovery or Factory Reset completes, the server automatically restarts. Before
taking the next step wait until the Health indicator light is solid aqua white .
8. You must reinstall the software on each of your computers, including the computer that you used
to perform the recovery - otherwise, you won’t be able to use the server.
9. Click Finish on the Server recovery complete dialog box.
10. The HP MediaSmart Server software will automatically be installed on the computer where you
performed the Server Recovery or Factory Reset.
Caution
If you did not close the HP MediaSmart Server Control Center, as indicated in step 1, you may see
a message asking you to reboot your computer. If you see this message, choose to reboot later.
Otherwise, rebooting may leave the server in a state where it cannot be configured, and you will
have to repeat the recovery or reset process.
229