10.
To clear the Setup or Power-On passwords if set, and clear any other settings, power down the
computer and remove the AC power cord and the computer hood.
11.
Locate the green two pin password jumper on header E49 (labeled PSWD) and remove it.
12.
Remove the AC power, wait 10 seconds until the unit AC power has drained out, then press the clear
CMOS button. This is typically a yellow push button (labeled CMOS).
13.
Replace the hood and AC power cord and turn the computer on. The passwords are now cleared and all
other user-configurable, non-volatile memory settings are reset to their factory default values.
14.
Enter the F10 setup utility.
15.
Select
File > Default Setup > Restore Factory Settings as Default
. This will set the default settings
back to the factory defaults.
16.
Select
File > Apply Defaults and Exit
.
17.
Shut down the computer, remove the AC power cord and place the (blue/green) jumper back on header
E49. Replace the computer hood and power cord.
If Computrace is enabled on the computer, see the service provider for instruction to disable the feature.
227
Содержание EliteDesk 705 G1
Страница 4: ...iv Safety warning notice ...
Страница 23: ...Misc parts Microtower MT chassis spare parts 13 ...
Страница 30: ...Misc parts 20 Chapter 2 Illustrated parts catalog ...
Страница 137: ...5 Lift to remove the speaker from the computer 3 To install the speaker reverse the removal procedures Speaker 127 ...
