88
8.
Plug in the computer and turn on power. Allow the operating system to start. This clears the current
passwords and disables the password features.
9.
To establish new passwords, repeat steps 1 through 4, replace the password jumper on pins 1
and 2, then repeat steps 6 through 8. Establish the new passwords in Computer Setup.
Clearing and Resetting the CMOS
The computer’s configuration memory (CMOS) stores information about the computer’s configuration.
The CMOS jumper resets CMOS but does not clear the supervisor and user passwords.
1.
Turn off the computer and any external devices, and disconnect the power cord from the power
outlet.
2.
Disconnect the keyboard, monitor, and any other external equipment connected to the computer.
WARNING!
To reduce the risk of personal injury from electrical shock and/or hot surfaces, be
sure to disconnect the power cord from the wall outlet, and allow the internal system components
to cool before touching.
CAUTION:
When the computer is plugged in, the power supply always has voltage applied to
the system board even when the unit is turned off. Failure to disconnect the power cord can result
in damage to the system.
Static electricity can damage the electronic components of the computer or optional equipment.
Before beginning these procedures, ensure that you are discharged of static electricity by briefly
touching a grounded metal object
3.
Remove the computer cover or access panel.
CAUTION:
Resetting the CMOS jumper will reset CMOS values to factory defaults. It is
important to back up the computer CMOS settings before resetting them in case they are needed
later. Back up is easily done through Computer Setup.
4.
Locate the header and jumper.
NOTE:
For assistance locating the CMOS jumper and other system board components, see the
Illustrated Parts & Service Map (IPSM) for that particular system. The IPSM can be downloaded
from
http://www.hp.com/support
.
CAUTION:
Make sure you have disconnected the AC power cord from the wall outlet. Clearing
the CMOS while power is connected can damage the system board.
5.
Remove the jumper from pins 1 and 2. Place the jumper on pins 2 and 3.
6.
Place the jumper back on pins 1 and 2.
7.
Replace the computer cover or access panel.
8.
Reconnect the external devices.
9.
Plug in the computer and turn on power.
NOTE:
You will receive POST error messages after clearing CMOS and rebooting advising you
that configuration changes have occurred. Use Computer Setup to reset any special system setups
along with the date and time.
Содержание 100B SFF
Страница 1: ...Maintenance Service Guide 100B SFF PC ...
Страница 4: ...iv ...
