HP Enterprise ProLiant DL380, Руководство по техническому обслуживанию и ремонту

Страница: 50 / 134

To replace the component, reverse the removal procedure.
Removing and replacing an expansion slot blank
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power from
the server by removing the power cord. The front panel Power On/Standby button does not shut off
system power. Portions of the power supply and some internal circuitry remain active until AC power is
removed.
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers,
or blanks installed. If the server supports hot-plug components, minimize the amount of time the access
panel is open.
Procedure
1. Power down the server ( Power down the server on page 36).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack ( Extend the server from the rack on page 37).
• Remove the server from the rack ( Remove the server from the rack on page 37).
4. Remove the access panel ( Remove the access panel on page 39).
5. Remove the PCIe riser cage:
• Primary or secondary PCIe riser cage ( Removing and replacing the primary or secondary PCIe
riser cages on page 45)
• Tertiary PCIe riser cage ( Removing and replacing the tertiary PCIe riser cage on page 46)
6. Remove the expansion slot blank.
50 Removing and replacing an expansion slot blank