Hoval 42-UltraOil 110, Техническая информация Инструкции по установке

Страница: 10 / 40

10 4 214 858 / 01
ASSEMBLY
2.4 Fitting the casing
CAUTION
The cable must not touch any hot parts.
The controller can be fitted on the right or left.
1. Hook the right and left side walls (8, 9, 10, 11, Fig.
07) into the top casing support rail (1, Fig. 07) and the
plinth rail (1a, Fig. 07).
- First, fit the front side walls (8, 11, Fig. 07)!
2. Hook the rear wall (12, Fig. 07) into the screws fitted
in the side walls.
Route the cable for the burner reset button
forwards to the boiler door. Attach the cable
to the casing side wall with the high-strength
cable gland.
Always install the burner plug on the side to-
wards which the boiler door is opened, see
also chapter 2.2.1 “Boiler door pivotable to
the left”.
3. Fit two special screws (12, Fig. 05) with counter nuts
to the side wall (8, Fig. 07) for the controller support.
12
13
Fig. 05
2.5 Installation of boiler control
1. Hook the electrical box (14, Fig. 07) into the side wall
(8, Fig. 07) with the recesses for the special screws
and secure it with two self-tapping screws Ø3.5x6.5
(13, Fig. 05) and serrated washers.
2. Pull the capillaries with the immersion sensors
(15, Fig. 07) through the opening in the side wall, in-
sert them into the immersion sleeve (15a, Fig. 07) as
far as the stop and fix in position with retaining spring
(15b, Fig. 07). Insert the burner plug (16, Fig. 07).
!
WARNING
Capillaries must not be folded or kinked
3. Lay the cable for the water pressure sensor (27, Fig.
07) through the opening in the side wall along the
cable duct towards the rear to the low-temperature
return and connect it.
4. Route the flue gas temperature sensor to the flue gas
collector and plug into the opening (17, Fig. 06) pro-
vided.
- Coat the sensor element with assembly lubricant
and insert the pressed part into the rubber stopper.
17
Fig. 06
5. Insert the rear casing cover (18, Fig. 07).
6. Attach cover plate (19, Fig. 07) with self-tapping scr-
ews Ø3.5x6.5 (20).
7. Fit cover plate (21, Fig. 07) using self-tapping screws
Ø3.5x9.5 (22).
8. Attach oil line holder (23, Fig. 07) to cover (24, Fig.
07) and hook the cover into the side walls.
9. Stick on labels and mount the holder for the system
manual (25, Fig. 07) on the side.
Installation of burner cover (24,26, Fig. 07)
see page 11.