hotset hotcontrol cDT+, Руководство по запуску, обслуживанию и эксплуатации

Страница: 11 / 200

Hotset GmbH
9
Start-up-, Service- and Operation Manual hotcontrol cDT+
Rev. 1.00.05
Subject to technical changes
The feet of the device may not be removed. Also, make sure that there is on the right and left side of the housing
sufficient distance (desktop housing at least 5 cm ) so that the waste heat can escape. Around the bottom and
below the bottom of the device, the air is drawn to cool the heat sink. This area must be kept clear that the air can
be drawn in unhindered.
Work like e.g. maintenance and repair may be carried out by authorized and skilled qualified personnel only. Only
qualified personnel, skilled and on the risks trained, may use the device. The relevant accidental regulations as
well as other general approved safety-relevant, occupational-medical norms have to be obeyed. Unauthorized
modifications of the device exclude liability of the manufacturer/supplier for resultant damages.
Before working on this device always switch-off the mains switch and make sure that the device is de-energized.
Protect the supply voltage against unintentional reclosing.
For person and property damages, resulting of not considering this Start-up, service and operation manual or not
considering these safety instruction, warranty claim terminates. For these damages the manufacturer assumes no
liability.
3.2 Intended use
The hot runner controller hotcontrol cDT+ is exclusively designed for temperature-dependent control of electric
heaters (e.g. injection molds) determined within the specifications. More specific descriptions are given in this op-
erating instructions.
For the parameterization of customer desired functions, the customer is responsible.
Uses other than the above shall be improper and exclude the liability of the manufacturer/supplier for any related
persons -, property - and consequential damage.
3.3 Maintenance
A further maintenance is not necessary. Maintain a clean surface of the operating unit. For cleaning use a damp
cloth. Avoid the use of solvents, cleansers and abrasives.
Warning, Possibility of
electric shock
General warning
sign
In all cases where the adjacent symbol is to see on the device, note the safety
instructions necessarily on the hot runner controller
hotcontrol cDT+ identi-
fied by this symbol/sign/label.
In all cases this Start-up-, Service- and Operation Manual must be consulted.
When properly used, the safety of the user and the device is guaranteed. The device may only
be used for the particular purpose.
With improper use the protection to persons and property may be impaired, and is thus no lon-
ger given.
Check regularly that the ventilation holes, located at the bottom of the device, are free of dust.