Hotpoint MC 057 AX0, Руководство по эксплуатации

Страница: 31 / 140

31
it en
the container.
7. Manually wash the hexagonal insert, its seal and
its metal ring with hot water and dishes soap.
Then, clean carefully.
8. Re-insert the hexagonal insert in the container
by holding it with your hand.
9. Insert the metal ring and turn clockwise until the
end of the stroke.
The container, the cover and the measuring
cup can be washed in the dishwasher.
To wash in the dishwasher please put the cup in
higher position, away from direct splashes of
water and use a medium-low temperature cycle.
Please regularly check the seal and lid integrity,
as well as the integrity of the hexagonal insert
seal, of the contacts and of the container’s connector.
Should they be worn out, please contact an authori-
sed service center.
Clean food residues after use
NEVER immerse the body in water. NEVER put
the engine under running water.
In some cases, depending on food and
preparations, there should be a residual film on
the bottom; try and remove this with a palette knife. In
case it is still there, try and remove it with a metallic
abrasive sponge.
Carefully wash by hand with hot water and soap for
dishes all the moving parts which get in contact with
food:
• the dispenser cap, the lid, the lid seal and the
palette blade,
• the mixing blade and the steam basket.
• the stainless steel blade and the ice crusher
blade with a small brush and taking them from
the upper part in order not to get cut.
We recommend to wash all blades immediately
after use; please avoid leaving them in contact
with food.
• Wash the container with vinegar to remove any
residual scale traces.
• Clean the engine and the container’s housing
with a well-squeezed wet cloth; please avoid
to get water in the area where the connector is
located.
• Please remove any food residues from the
security device which is located on the column
on the base of the product.
Carefully dry the washed parts.
Cleaning using the engine
At the end of the processing, please clean the inside
of the container as follows:
• Remove from the container the food and the
accessory you’ve used.
• Insert the stainless steel blade.
• Please fill the container with hot water up to 1
litre and add a drop of dishes soap. If you don’t
want to use dishes soap you can add thick salt,
in order to better remove food residues, or lemon
juice, in order to eliminate any smells.
• Close the cover and insert the dispenser cap.
• Activate the PULSE button for the time you
deem necessary.
• Empty the container and wash it under running
water.
PROBLEMS AND SOLUTIONS
Error/Problem Causes Solutions
E1 Engine overload Reduce the quantity
of food inside the
container.
Pull out any food
residues from the
blades.
E3 The container is not
properly fixed to the
base.
The container was
removed during the
processing or during
a program.
Correctly fit the
container.