21 of 40
Indesit
Company
Service Manual UK
English
FAULT CODES & DIAGNOSTICS
If an error is detected in programme, the Fault Code Number will flash on the console display.
N.B.
In a Fault Condition the
On/Off
LED will also flash.
•
Note 1.
If the water is turned off after approximately 2 minutes the machine will beep every 2 seconds,
then display a fault code.
•
Note 2.
In the event of any of the above codes being displayed, after the fault has been rectified it will
be necessary to reset the dishwasher.
• ** This fault code is only applicable to the LFT321HXUK and LFT3214HXUK.
•
Resetting after a Fault
This is achieved by switching OFF the dishwasher with the On/Off switch and waiting 30 seconds.
The dishwasher is then ready for use.
Very Short Programme Times:
If the dishwasher completes the cycle in a very short time (with very poor wash results) see
’BLOCKED FILTER’ on page 14.
Flashing
Number
Fault
Possible Cause(s)
1
Overflow (water in
base pan).
Leak from water line.
2
Valve or Turbine faulty
or disconnected.
Inlet valve, connections, valve letting by when off.
3
Time out draining
Pump connections, blockage, module, circulation pump.
4
Thermistor circuit
Thermistor / module.
6
Time out filling
Customer's tap, Inlet valve, connections, timer, water turbine.
7
Turbine faulty
Module has detected no Turbine rotation. check turbine and
wiring
8
Time out heating
Heater Open circuit or NTC thermistor detached from casing.
9
Software recognition
error
Module not programmed, wrong keypad
10
Heating circuit
Heating element, connections, module, relay, pressure
switch.
11 **
Wash Pump Faulty
Wash Pump faulty, or wiring/connections between pump
motor and module faulty.
12
Communication Error ---
13
Non-operative module ---
15
Virtual Sensor
---
