10 of 40
Service Manual UK
Indesit
Company
English
BASIC MACHINE USE
Setting a Programme
1.
Open the door and turn the machine On.
2.
Press the P button, after each press, the display number will cycle to the next programme
number, until the desired Programme is shown.
3.
Close the door, The machine will Start after about 10 seconds.
Cancelling a Programme in progress
1.
Press and Hold the On/Off button until the machine beeps and the lamps all go out.
The programme is now cancelled.
End of Cycle
The Programme number will
flash
in the display when the final drying part of the programme is
completed.
Note:
If the machine is silent and when the door is opened and the Programme Number is
permanently
displayed,
the cycle has not finished
. Close the door and allow the programme
to continue. During the final part of the Drying Cycle the machine is paused.
On/Off Lamp Flashing
If the ON-OFF Lamp is flashing as well as a programme number the machine has a fault, see
Fault Codes and Diagnostics.
Adjusting the height of the upper rack
In order to make it easier to arrange the crockery, the upper rack may be moved to a higher or lower
position.
The height of the upper rack should be adjusted
WHEN THE RACK IS EMPTY
.
NEVER
raise or lower the rack on one side only.
If the rack is equipped with a Lift-Up device* (see figure), lift it up by holding its sides. To restore the
lower position, press the levers (A) at the sides of the rack and follow the rack down.
