horsch SW 600, Руководство пользователя

Страница: 65 / 100

SW600 Owner’s Manual – Version 1.2 07/2018 65
www.horsch.com
Servicing the Meter Unit
The metering unit does not require any specific maintenance. Clean and check the metering function
and the hydraulic drive motor at the end of the season.
Door for Larger Seeds
1. There is a special seed door for seeding Garbanzo beans that has been modified to accept 3/16”
stainless steel spacer to move the door away from the metering unit to reduce the drag and
prevent motor overloads and jamming up of the meter roller in the metering unit.
When adjusting the rubber flat down to allow for the larger seed sizes to pass by the rubber strip
it may be necessary to slot the holes in the strip, or using a razor blade or utility knife cut a thin
strip of rubber off the rubber strip to reduce the friction of the seeds trying to pass by the rubber
strip.
If you do cut some of the rubber off it may let smaller seeds slip by when seeding smaller grains
such as wheat, barley, millet or similar type seeds. It is recommended that the customer have
this special door available to be installed when seeding garbanzo beans or soybeans.
Stainless Steel spacer (left), special door (center), standard door (right)
2. Using a razor blade or utility knife you can slot the holes of the rubber strip so it can be lowered
away from the metering roller, allowing for larger seeds to easily pass by with little effort and
reduce drag on the drive motor.