horsch SW 600, Руководство пользователя

Страница: 56 / 100

56 SW600 Owner’s Manual – Version 1.2 07/2018
www.horsch.com
Table 1: Standard Measuring Units Table 2: Metric Measuring Units
Whenever the metering unit is in operation, care must be taken that the components are absolutely tight.
Leakages can lead to metering errors.
When assembling the metering unit, the supporting surfaces must be sealed and the housing must not
be distorted when being attached.
The metering unit is closed at the bottom by the entering chamber. In this, the seed is entered into the
air flow.
When calibrating, the seed is removed from the metering unit via the opening in the metering chamber.
Subsequently, the cover must again be tight and firmly closed.
Meter Roller Alignment
Meter Roller NOT centered Meter Roller IS centered
To align the Meter Roller in the meter housing correctly, you must use the washers that are at each end
of the meter shaft to position the meter roller in the center of the housing. You must make sure to install
the C-clip (Part # 00170053 – shown in picture below) in the bearing holder to assure that the meter stays
centered. If the meter roller is not centered correctly, transfer correct thickness washer from one side to
the other as needed.
No. Size in” Color Hole
in.” Depth
in.” No. of
Holes
1 2.44 Red .87 .39 16
2 6.10 Blue .95 .43 30
3 15.26 Black
4 30.50 Honey Color
5 48.82 Stainless
No. Size cm Color Hole
mm Depth
mm No. of
Holes
1 40 Red 22 10 16
2 100 Blue 24 11 30
3 250 Black
4 500 Honey Color
5 800 Stainless