Commissioning
NOTE
These work activities may be carried out only by
persons trained by HORSCH for this purpose.
WARNING
Increased danger of accidents during commis-
sioning.
¾
Observe the notes in the safety chapter.
Delivery
The machine with implements is normally de-
livered completely assembled on a low loader.
If parts or assembly groups had to be disas-
sembled for transport purposes, these will be
assembled locally by our distributor or field
technician.
Depending on the design of the low loader the
machine can be unloaded with a tractor, or
needs to be lifted off with suitable lifting gear
(forklift truck or crane).
¾
Use only lifting equipment and lifting gear with
adequate lifting capacity and approval!
Lifting and lashing points are identified by labels.
When using other lifting points pay careful at-
tention to the centre of gravity and the weight
distribution. These points must, in any case, only
be on the frame of the machine.
Transport
Depending on country-specific regulations and
working width the equipment can be transported
on public roads either attached to a tractor or on
a trailer or low loader.
¾
The permissible dimensions and weights for
transport must be complied with.
¾
The tractor must be large enough so that
sufficient steering and braking abilities are
ensured.
¾
If the machine is hitched up in two-point mode,
the tractor link arms must be blocked against
swinging sideways.
¾
On a trailer or low loader the machine must
be secured with tensioning straps or other
means.
¾
Attach lifting tackle only at the marked points.
¾
Pay attention to the notes in the
Ballasting
chapter.
Installation
Instruction of the operator and initial installation
of the machine will be carried out by our service
technicians or distributors.
Any preceding use of the machine is prohibited!
The machine can only be released for opera-
tion after the instruction session conducted by
our service technician / distributor and after the
operating instructions have been read.
WARNING
Increased danger of accidents during installation
and maintenance.
¾
Read these operating instructions and become
acquainted with the machine before starting
this work.
Depending on scope of equipment
¾
Take loosely delivered parts off the machine!
¾
Check all important screw connections!
¾
Lubricate all grease nipples!
¾
Check air pressure in tyres.
¾
Check all hydraulic connections and hoses
for correct fastening and function!
¾
Immediately rectify any occurring damage or
have it corrected!
Installation of the drill controls is described
in the corresponding instruction manual.
31
