Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Руководство пользователя

Страница: 89 / 162

HRO
Systems
Horizon
Seafari
“Section I” System Troubleshooting Guide
“Start” switch is depressed but the system does not attempt to start:
Fault LED lamp is illuminated and requires resetting by pressing Fault Reset Switch at the touch pad.
Power Source Line is switched off, reset the Power Source Circuit Breaker.
Blown fuse in the controller, check fuse condition.
Micro Processor has locked up due to a voltage spike from the Power Source. Turn power off for a
minimum of 20 seconds to reset the Micro Processor.
Power source is dropping below the industry standard of 15%, at the instant of starting, preventing the
electronic circuit from latching. Check the power source to ensure that it continually delivers the proper
power to the System. If voltage drops below acceptable standards for even a micro second this causes
the electronic circuit to not latch.
Controller is wired improperly or there are loose wires, check wiring with proper wiring diagram
Start switch at the touch pad is defective and not closing to make the circuit.
“Stop” switch is depressed but the system does not attempt to stop:
Micro Processor has locked up. Turn power off for a minimum of 20 seconds to reset the Main PCB.
Stop switch at the touch pad is defective and not closing to make the circuit.
Water damage to the printed circuit board is shorting the stop circuit and causing the system to remain in
operation.
Fuse in controller blows at start up:
Low or high voltage into the system, correct at the source into the system.
Defective component that relies on the fuse for power:
3-way solenoid valve U.V. Sterilizer
Printed Circuit Boards
Touch Pad
Shorted wire, locate shorted wire and repair it.
Page I - 15