Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Руководство пользователя

Страница: 65 / 162

HRO
Systems
Horizon
Seafari
“Section G” System Start Up Procedure
G. STARTUP PROCEDURE
1. Check the level of the oil in the High Pressure Pump
crankcase. Ensure that the oil level is higher than the
center of the sight glass.
2. Open the Inlet Sea Cock Valve [2] fully.
3. Position the Clean/Rinse Inlet Valve [4], if installed, to the
normal operating position.
4. Position the Clean/Rinse Outlet Valve [35], if installed, to
the normal operating position.
5. Open any auxiliary Valve within the incoming Feed Line.
6. Open any auxiliary Valve in the Outgoing Brine
Discharge Line.
7. Open any auxiliary Valve in the Outgoing Product Water
Line.
8. Set the Multi Media Filter Valves, if installed, for the
Normal Operating Position.
9. Fully Open the Back Pressure Regulator Valve [33].
10. Switch the Electrical Power Source to the Salinity
Controller [56] "ON".
11. To start the system press the “Start” switch, or press the
“Booster Pump” switch and then the “Start” switch.
If the System automatically shuts off after several
seconds of operation, look at the Touch Pad to
determine whether a fault has occurred. If so, correct
fault and repeat Step 11. For fault explanation, see
following page.
12. Bleed all air from the Commercial Pre-filter [14] and
Oil/Water Separator [17] by opening the air bleed
valve located at the top of the each housing [15 & 18]
and close when water displaces all of the air.
13.
Slowly adjust the Back Pressure Regulator Valve [33]
by turning clockwise to increase the pressure up to the
proper setting (850 psi for 35,000 ppm seawater).
For
BRACKISH WATER operation, adjust the
pressure from 100 PSI to 850 so the product water
output, is within system specifications.
Hourly Production
Gallons / Liters
Horizon Seafari 420-1 18 / 66
Horizon Seafari 630-1 26 / 99
Horizon Seafari 840-1 35 / 133
Horizon Seafari 740-2 31 / 189
Horizon Seafari 1160-2 48 / 183
Horizon Seafari 1480-2 62 / 234
DO NOT EXCEED FLOW SPECIFICATIONS.
14. If any abnormality develops, stop the System and
correct the problem.
15. Use the Product Water Flow Meter [42] to measure the
product flow. The salinity of the Product Water
diminishes gradually, until the product water reaches
the factory setting at which time the product water
passes into the Post Filtration components, & onto the
Ship’s Storage Tank [46].
16. Check for unusual noises or other occurrences.
Backpressure
Regulator Valve.
System Controller
Main Power
Enclosure.
Reverse Osmosis
Membrane(s)
Brine & Product Flow Meters
System Feed Water
Low Pressure Gauge
System High Pressure
Gauge
Page G - 1