Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Руководство пользователя

Страница: 100 / 162

HRO
Systems
Horizon
Seafari
“Section J” System & R.O. Membrane Element Storage Procedure
Page J - 9
11. Fill a separate plastic bucket or container (1/2 to
2 gallons) 1/2 full with product water. Add the
full contents of the HRO CC-1, CC-2, or CC-3
Cleaning Chemical to the water in the plastic
bucket.
USE ONLY ONE CHEMICAL AT A
TIME.
Mix and thoroughly dissolve the solution in the
container. Pour the dissolved solution into the
Rinse/Clean Tank [50].
NOTE: The correct mixture ratio for the
Cleaning Chemical (CC) is one bottle per 20
gallons of product water. The chemical is mixed
first in a small bucket and then added to the water
in the tank. This makes the chemical easier to
dissolve into the water in the tank.
12. Position the Rinse/Clean Outlet Valve [35] to the
Clean/Rinse Tank [50] return for a closed-loop
re-circulation to and from the Clean/Rinse Tank
[50].
13. Press the “Start” switch to begin re-circulating
the Cleaning Chemical solution from the
Clean/Rinse Tank, through the System and back
into the Clean/Rinse Tank.
Do not pressurize the
system above 50 psi maximum.
14. After approximately 60 minutes of re-circulation,
stop the system.
15. In order to empty the Clean/Rinse Tank, position
the Rinse/Clean Outlet Valve [35] to the Brine
Discharge, normal operating position.
16. Press the “Start” switch to discharge the solution
out the Brine Discharge Thru Hull Fitting [36].
17. Just prior to depleting the Cleaning Chemical
solution from the tank, stop the system.
18. Refill the Rinse/Clean Tank [50] with non-
chlorinated product water.
19. Position the Rinse/Clean Outlet Valve [35] to the
Clean/Rinse Tank [50] for Rinse Re-circulation.
20. Press the “Start” switch to re-circulate the water
from the Rinse/Clean Tank, through the system,
and back into the Rinse/Clean Tank. Continue
rinsing for 20 minutes.
21. After 20 minutes stop the system by pressing the
“Stop” switch.
22. In order to empty the Clean/Rinse Tank, position
the Rinse/Clean Outlet Valve [35] to the Brine
Discharge, normal operating position.
23. Press the “Start” switch to discharge the rinse
water out the Brine Discharge Thru Hull Fitting
[36].
24. Just prior to depleting the rinse water from the
tank, stop the system.
25. Refill the Rinse/Clean Tank [50] with non-
chlorinated product water.
26. Position the Rinse/Clean Outlet Valve [35] to the
Brine Discharge, normal operating position.
27. Start the system to begin rinsing the System, and
discharging out the Brine Discharge Thru Hull
Fitting to waste.
28. Just prior to depleting the Final Rinse Water from
the tank stop the system.
The System is now ready for additional cleaning,
Storage, or use.
If further cleaning is necessary, repeat steps 10
through 28 for each additional cleaning.
If cleaning is completed and the System is to be
stored, go to the beginning of this section and
review the
Storage Procedures and Cautions .
If cleaning is complete and the System will be
operated again within a short period of time,
proceed to step 29 below.
29. Position the Clean/Rinse Inlet Valve [4] towards
the Sea Strainer, normal operating position.