Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Руководство пользователя

Страница: 50 / 162

HRO
Systems
Horizon
Seafari
Self Contained and Modular Style
Page E - 18
24.
Electrical Connections: Electrically connect, if not already connected, the following to the Horizon Seafari
Controller:
Optional U.V. Sterilizer Optional Fresh Water Flush Valve
Optional Remote Unit Main Incoming Power
Booster Pump Motor High Pressure Pump (Modular)
High Pressure Pump Thermal (Modular) Low Pressure Switch
Salinity Probe (Modular) Soft Motor Starter (See Appendix A-4 for Installation Instructions)
Refer to Appendix A for electrical information and wiring diagrams.
Remote:
Often, the Remote Control Touch Pad is mounted in a recessed hole. After measuring the Remote Control Panel, routing
out the indent and cutting the Cable hole, place the Touch Pad into the indent and check for sizing. Clean up the indent as
required for a good fit. If the indent was made in wood or other porous surface then it is best to seal the surface of the
indent so that the Touch Pad properly adheres to the indent surface. Once the indent hole has been sized and sealed
ensure that the indent is “squeaky clean” and free of dust so that the double stick tape attached to the Touch Pad properly
adheres to the indent surface. Remove the green paper from the back of the Touch Pad to expose the double stick tape
attached to the back of the Touch Pad. Position the Touch Pad directly over the Indent and press firmly into place for a
permanent bond.
1.125" [28.6] 0.750" [19.1]
0.750" [19.1]
0.187" [4.8]
2.500" [63.5]
3.000" [76.2]
Remote Touch Pad Cut Out
Dimensions For Mounting
R0.250" [R6.4] HRO-RCU "Re
VIEW IS FROM TOP mote"
OF PAD
ad Thickness = 0.100" / 2.5 mm P