horiba JOBIN YVON SYNAPSE, Руководство пользователя

Страница: 16 / 116

System Requirements
6
General Safety Requirements
The following general safety precautions must be observed during all phases of operation
of this instrument. Failure to comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of design, manufacture and intended
use of instrument. HORIBA Jobin Yvon assumes no liability for the customer’s failure to
comply with these requirements. Certain symbols (listed on the following page) may be
found on the instrument, supporting equipment or used throughout the text for special
conditions when operating the instrument.
To prevent permanent damage to your system, please observe the following safety
precautions:
•
Do not block the air vents of the detector head or power supply unit. Preventing
the free flowing air can overheat and permanently damage the CCD.
•
Prior to the application of power, ensure that the ground prong of the power
supply power cord is properly connected to a wall outlet or power strip that
provides for a protective earth ground connection.
•
Do not connect or disconnect any cables to or from the detector head while the
system is powered on.
•
The sensor and detector head electronics are all very sensitive to Electrostatic
Discharge (ESD). When installing the system, stand on a conductive mat and wear
a grounded ESD wrist strap.