Français
: voir la page 21 •
Español
: vea la página 41
15 69-2091EFS—07
Replacing system components
Thermostat
To replace a thermostat, install batteries and follow the procedures on pages 5-6
to link it to the wireless network. If necessary, modify settings as needed (see
tables on pages 9-11).
Remote control & outdoor sensor
To replace a remote control or outdoor air sensor, install batteries and follow the
procedures on pages 5-7 to link it to the wireless network.
Equipment interface module (EIM)
After installing a new EIM, you must re-set the thermostat and remote control to
communicate with the new EIM, as described below.
At the thermostat:
1
Press and hold
the
FAN
and
s
buttons for 3 seconds.
2 Press
BACK
twice to display Function 39 (wireless setup).
3 Press
t
to change Function 39 setting to 0 (disconnect from old EIM).
4 Follow the procedures on pages 5-6 to link to new EIM.
At the remote control:
1
Press and hold
the blank space (or arrow if present) in the lower right
corner of the screen until the display changes (about 3 seconds).
2 Press
REMOVE
,
then
YES
to disconnect from old EIM.
3 Follow the procedure on page 7 to link to new EIM.
Press and hold for
about 3 seconds.
