Honeywell Miller VC300, Руководство пользователя

Страница: 18 / 48

18
KEEP THIS MANUAL FOR FUTURE USE - DO NOT THROW AWAY!
3 SYSTEM
Important!
The Miller VC300 arrester must be used only with a Vi-Go Cable Arrest System with manual
pass-through brackets. For further information see the system installation guide.
4 ANCHOR DEVICE EXTENSION POST
The Honeywell Miller Vi-Go extension post is a certified anchor point for fall protection for 2 persons
in accordance to EN 795. The eye of the anchor steel plate (pos. 1) serves as anchor point. Therefore
it is possible when you are changing from vertical to horizontal to protect you against falling.
The characteristic load affecting the extension post must not exceed 22 kN/4945.8 lbf under
any circumstances.
Please pay attention to the safe standing of the user when working in dangerous areas. Tripping
points in the entrance and working area have to be avoided.
Functional capability of the system has to be inspected visually before and while using the installed
fall protection system.
Warning !
The anchor device must no longer be used anymore if the anchor eye was charged by a fall. In
this case the anchor device has to be checked by a competent person and changed if necessary.
The anchor device Honeywell Miller Vi-Go extension post may only be used in combination with the
following safety equipment:
• falling hazard fall arrest system in accordance to EN 363 and energy absorber EN 355
• rescue systems in accordance to EN 1496, 1479 and 1498
The system of the personal protective equipment against falling (only with energy absorber) or rescue
system must be chosen that a collision of the user with the ground or collision with other bars can be
avoided. For that the information for use of the manufacturer must be checked.
In order to secure against fall from a height, the karabiner hook (pos.1) of the lanyard has to be installed
on the eye of the anchor steel plate (pos. 2) and locked to avoid unintended disconnecting.(Fig.3)
Danger!
The karabiner hook of the lanyard must not disconnect from the anchor device before the user
is protected by another solution against a fall.
5 USE
Important!
Inspection before climbing:
• Before each use, inspect the cable, the cable tension, the fall arrester, the intermediate fixings
and the karabiners for usability.
• The fall arrest system must not be used if defects have been noted or in case of doubts as to
its proper function. Before further use, an inspection by a competent person is needed or the
defective parts must be replaced.
• Before and during use it should be planned how to affect a rescue safely and effectivel y.
Each user must secure themselves to a separate fall arrester.
The fall arrester, properly used in connection with a full body harness, protects its user during ascent
and descent against falls.