Honeywell MAXPRO MPIP2000U Series, Инструкция по установке и настройке, Страница: 35 / 77

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series Installation and Setup Guide
800-23044 Rev. A draft_11 35
# Item
Terminal
or
connector
Connect with
H Vplex BUS 1 + V-Plex bus 1 +
– V-Plex bus 1 –
I IB2 BUS 1 +12V AUX1 12 VDC supply terminal for devices
connected to IB2 bus 1.
– 0 VDC supply terminal for devices connected
to IB2 bus 1.
C IB2 bus C
D IB2 bus D
J IB2 bus 1 Quick connect plug for IB2 BUS 1 (can be used for
module stacked on top of main board; quick connect
cable is included).
K LTE Cell
Radio USB and
PWR/IO Connectors for the 4G/LTE module
L For future use.
M Ethernet WAN Network with internet connection to the
cloud.
N Relay 2 NC Normal Closed terminal, output relay 2
C Common terminal, output relay 2
NO Normal Open terminal, output relay 2
Relay 2 is only available on the MPIP3000 series.
O Relay 1 NC Normal Closed terminal, output relay 1
C Common terminal, output relay 1
NO Normal Open terminal, output relay 1
– Spare 0 VDC connector.
P Triggers For outputs. For details, see Wiring Outputs on page 48.
Can also be used for a self-activating bell. For details, see
Installing a Self-Activating Bell (SAB) on page 47.
Q Jumpers for low-voltage triggers. For details, see Wiring Outputs on
page 48.
R Zones 9, 10 For zones (sensor contact inputs). Can be used for 2-wire
smoke sensors or as standard burglary zones.
For details, see Wiring Inputs (Zones) on page 39.