Honeywell ADEMCO VISTA-12A, Инструкция по установке и настройке

Страница: 18 / 112

Installation and Setup Guide
2-12
Installing the RF Receiver
Use one of the following receivers:
RF Receiver Number of Zones
5881ENL up to 8 (including keyfob
buttons)
5881ENM
up to 16 (including keyfob
buttons)
1. Set Device Address to “00” as described in its
instructions (set all switches to the right, “off”
position).
2. Mount the
receiver
, noting that the RF receiver can
detect signals from transmitters within a
nominal range of 67m.
3. Connect the
receiver's
wire harness to the control's
keypad terminals. Plug the connector at the
other end of the harness into the receiver. Refer
to the installation instructions provided with the
receiver for further installation procedures
regarding antenna mounting, etc.
If power
supervision
is required, use the Trigger
Module terminals as described in the Aux
Power Supervision Connections paragraph
in the Wiring to Keypads section (page 2-3).
Notes
•
The receiver is supervised and a trouble
report is sent (“CHECK 100” displayed) if
communication between the panel and
receiver is interrupted, or if no valid RF
signals from at least one supervised
transmitter are received within 12 hours.
•
Only one receiver can be installed in a
system.
If the receiver is mounted remotely:
•
Place the RF receiver in a high, centrally
located area for best reception.
•
Do not locate the receiver or transmitters
on or near metal objects. This will decrease
range and/or block transmissions.
•
Do not locate the RF receiver in an area of
high RF interference (indicated by frequent
or prolonged lighting of the LED in the
receiver; random flicker is OK).
•
Do not locate RF receiver closer than 3m
from any keypads to avoid interference
from the microprocessors in those units.
Figure 8. 5881EN RF Receiver (cover removed)
WIRELESS ZONE NUMBERS
transmitter zones 9-24
button or transmitter zones 49-64