COMPONENT MAINTENANCE MANUAL
00001059
TASK 21-22-91-100-803-A01
3.
Cleaning of Component Parts
A.
Reason for the Job
WARNING:
– DO NOT BREATHE THE FUMES. THE SOLVENTS ARE DANGEROUS.
– USE EYE PROTECTION. DO NOT LET THE SOLVENTS TOUCH YOUR SKIN.
– CLEAN THE PARTS IN A ROOM WHERE AIRFLOW IS SUFFICIENT.
– DO NOT CLEAN NEAR AN OPEN FLAME.
CAUTION:
– CAREFULLY OBEY THE CLEANING PROCEDURES, OR REPLACE THEM WITH
A PROCEDURE WHICH IS SPECIFIED BY THE MANUFACTURER IF YOU USE
EQUIVALENT PRODUCTS.
– AFTER YOU COMPLETE THE PROCEDURE, YOU MUST PUT PROTECTIVE
CAPS OR APPLICABLE PACKAGING MATERIAL ON THE PARTS.
Self-explanatory
B.
Job Set-up Information
(1)
Referenced Information
REFERENCE
PAGE BLOCK
DESIGNATION
TASK-21-22-91-100-804-A01
4000
CLEANING PROCEDURE TABLE
C.
Job Set-up
Not applicable
D.
Procedure
SUBTASK 21-22-91-160-003-A01
(1)
Cleaning of the Component Parts
(a)
Clean each part to remove oil, grease and dirt.
(b)
Make sure that the mating areas are fully free from packing material or sealing compound.
(c)
Use the applicable cleaning procedure (Ref. TASK 21-22-91-100-804-A01).
E.
Close-up
Not applicable
21-22-91
Page 4003
Dec 15/06
The document reference is online, please check the correspondence between the online documentation and the printed version.