TUXEDOW INSTALLATION AND SETUP GUIDE
28
Advanced Setup
Advanced Setup allows access to
Power Mode Setup, Night Setup, Keypad Reset, End-user License
and
Factory Default
menus.
At any time when a test is not being performed, you can touch the back icon to return to the previous screen or touch the home icon to return
to your home page.
Residential System Notes
•
If the Clean Me option is set, when the maintenance signal is received a “Fire Maintenance” message and the Display Faults
icon is shown. However, if you display the faults, zone 1 is not shown as a faulted zone.
•
If RF Jam Reports are selected and RF Jam is detected, the User Authorization screen displays “Trouble ZN100 RF
Receiver”. If you enter the console emulation mode, the display shows “Check 90 RF Receiver Jam”.
•
Do not use the Custom Word reminder feature.
Power Mode Setup
To set the Power Mode functions, from the Home screen, touch the
Setup
,
System Setup
and
Advanced Setup
icons.
ICON ACTION
NOTES
1. Enter your Authorized Code and touch
the
Power Mode Setup
icon. Check
the box to enable
Power Save Mode
.
2. Select the option to
Turn off Network
or
Override Display Settings.
3. Touch
to save
settings. Touch
to return to the previous screen.
When Power Save Mode is selected,
There are two options that are available:
Turn-Off Network -
No firmware updates will be completed until power and
network are restored
Override Display settings
can be overwritten and the TUXEDOW operates
in low power mode:
•
Brightness control decreases to minimum level.
•
Return To Homepage After time resets to 30 seconds.
•
Auto Slide Show After time reverts to Never.
•
When AC power is restored, the original Display settings resume
Night Setup
To set the NIGHT function, from the Home screen, touch the
Setup
,
System Setup
and
Advanced Setup
icons.
ICON ACTION
NOTES
1. Enter your Authorized Code and
touch the
Night Setup
icon.
2. Select the arming mode to be
activated when
NIGHT
is selected on
the Arming screen.
The
NIGHT
icon can be set to arm the system in one of five modes:
•
Away - Arms all zones with entry delay.
•
Stay - Arms perimeter zones with entry delay.
•
Instant - Arms perimeter zones without entry delay.
•
Maximum - Arms all zones without entry delay. Not to be used for
ANSI/SIA CP-01 installations.
•
Night (Residential Panels Only) – Arms all perimeter zones plus
all zones listed in Zone List 5.
Touch
to save
settings. Touch to return to the previous
screen.
Keypad Reset
To activate the Keypad Reset function, touch the
Setup
,
System Setup
and
Advanced Setup
icons.
ICON ACTION
NOTES
1. Enter your Authorized Code and
touch the Keypad Reset icon.
2. Select OK to reset (power cycle) or
Cancel to quit.
The message is displayed:
Processor Reset: Are you sure you want to reset?
Panel information is downloaded
